An Introduction to Design of Concrete Slabs on Grade for Professional Engineers

Sprache: Englisch

Verlag: Independently Published Jul 2026, 2026

9798188874315

Serie: Buch 76 von 76 - Structural Engineering

Anbieter: AHA-BUCH GmbH, Einbeck, DeutschlandAHA-BUCH GmbH

Verkäufer/-in mit 5 Sternen

Verkäufer:in bei ZVAB seit 14. August 2006

Softcover

Zustand: Neu

EUR 60,72

EUR 35,00 Versand 
Versand von Deutschland nach USA

Anzahl: 2 verfügbar

In den Warenkorb
30 Tage kostenlose Rückgabe

Artikelbeschreibung des Verkäufers

Neuware - There are several factors that have a considerable effect on determining the design thickness of a concrete slab-on-ground and can be divided into above and below slab-on-ground factors. The type, strength, and uniformity of the subgrade or subbase are the below slab-on-ground factors and are discussed. The type of loads, magnitude of loads, and frequency of moving loads travel are the above slab-on-ground factors and are addressed. The concrete mixture design and strength of the slab-on-ground is discussed. In this discussion, the key factor in the design of a slab-on-ground-its thickness, h. Three classical design methods and the finite element (FE) method are available to engineers for determining the slab-on-ground thickness. The classical design methods are: Corps of Engineers (COE), Portland Cement Association (PCA), and Wire Reinforcement Institute (WRI). They are based on continuous support to the slab-on-ground and uniform modulus of subgrade strength, k. The slab thickness calculation is insensitive to minor changes in k-values; therefore, it is not critical to obtain an accurate k-value. It is, however, directly related to the strength of concrete defined by the concrete flexural strength, fr, which is measured in accordance with ASTM C78. The COE and WRI methods use a value equal to 7.5, while PCA method uses a value equal to 9. For heavy loading, however, it is recommended to use the lower factor of 7.5 with a factor of safety equal to 2; refer to Section 3-10. The FE method, Section 5-12, unlike the classical methods, does allow for variable modulus of subgrade in the analysis. Slabs-on-ground are designed for the critical load or load combinations that generate the maximum stress and maintain surface cracking at an acceptable level. Typically, forklifts control the flexural design of slabs-on-ground, storage racks control punching shear and concrete bearing design, while distributed live loads control negative moment design in aisles between distributed loads, dowels at joints, and settlement of slabs-on-ground; refer to Figure 5-1 (Packard 1996). Accordingly, the SER will design the overall slab-on-ground thickness for the allowable moving load that controls flexural stresses. The SER will then check for punching shear of concentrated, line, and distributed loads at localized areas where constructed, applied, or both, verifies that excessive settlement does not occur below a stationary load, and ensures that cracks are not developed in aisles between distributed loads. The design procedure covers subgrade conditions, steel reinforcement, and various details such as jointing, dowels, and the inclusion of vapor retarder, if needed.…

Bestandsnummer des Verkäufers 9798188874315

Titel
An Introduction to Design of Concrete Slabs on Grade for Professional Engineers
Autor
J. Paul Guyer
Verlag
Independently Published Jul 2026
Erscheinungsjahr
2026
Zustand
Neu
Einband
Taschenbuch
Sprache
Englisch
ISBN-13
9798188874315
Artikelgewicht
256 Gramm
Abmessungen
279x216x5 mm
Serie
Buch 76 von 76: Structural Engineering

AHA-BUCH GmbH

Einbeck, Deutschland

Verkäufer/-in mit 5 Sternen

Verkäufer:in bei ZVAB seit 14. August 2006

Versandkosten von Deutschland nach USA

Artikel7 bis 10 Werktage5 bis 7 Werktage
Erster ArtikelEUR 35,00EUR 45,00
Die Versandzeiten werden von den Verkäuferinnen und Verkäufern festgelegt. Sie variieren je nach Versanddienstleister und Standort. Sendungen, die den Zoll passieren, können Verzögerungen unterliegen. Eventuell anfallende Abgaben oder Gebühren sind von der Käuferin bzw. dem Käufer zu tragen. Die Verkäuferin bzw. der Verkäufer kann Sie bezüglich zusätzlicher Versandkosten kontaktieren, um einen möglichen Anstieg der Versandkosten für Ihre Artikel auszugleichen.

Zahlungsarten

  • Visa
  • Mastercard
  • American Express
  • Carte Bleue
  • Apple Pay
  • Google Pay
  • Banküberweisung
  • PayPal
  • Vorauskasse

Shopbeschreibung

Das Unternehmen AHA-BUCH GmbH: Seit der Gründung von AHA-BUCH im Juli 2005 ist unser Hauptziel, zufriedenen Kunden so schnell und so preisgünstig wie möglich ihren Bücherwunsch zu erfüllen. Unsere Firma beschäftigt 16 Mitarbeiter, die nur ein Ziel kennen: den Kunden und seine Wünsche! Auf über 3700 m2 Fläche haben wir über 100.000 Bücher, Modernes Antiquariat und Spiele auf Lager.

Spezialisierung

Kinderbücher & Kinderhör Casetten, German Books, Software, Natur & Tiere, Ratgeber, Sachbücher, Englische Bücher, Medizin & Gesundheit, Universität & Studium

Unternehmensdaten der Verkäuferin bzw. des Verkäufers

AHA-BUCH GmbH

Garlebsen 48
Einbeck, Deutschland 37574